Honeywell RAPID EYE K9696V2 - Manual (Page 79)

More FAQs: Find-it
7–5
Fig. 45. Input configuration during a maintenance session. By default,
alarm/control inputs are configured as NO. 5–7
Fig. 46. Schematics: (a) normally open, (b) normally closed or (c) end-of-line 5–7
Fig. 47. Settings for monitoring a unit. 5–9
Fig. 48. FAULT RELAY connector on Multi-Media unit’s back-panel, showing
connection to an external alarm panel. 5–10
7.4 More FAQs
In Europe, a UPS is required to meet EN50130–4 Euro Norm. 1–3
Effective video feeds are a major component of any CCTV system. 1–8
Please do not remove factory seals on a Multi-Media unit. 2–1
Do not connect USB devices or a printer to a Multi-Media unit. 2–3
In Europe, a UPS is required to meet EN50130–4. 2–4
Honeywell recommends that a line conditioning uninterruptible power supply
(UPS) be used with the Multi-Media unit and the cameras connected to the unit. 2–5
If cameras are turned on after the Multi-Media unit, they will not be auto-detected
by the unit.
2–5
Honeywell recommends powering down a unit before connecting hardware to it.
See 2.4.1: Powering Up and Down, p. 2–5.
2–6
Lens selection and angle of the camera can be critical to the usefulness of
images obtained in a closed circuit television (CCTV) system.
2–7
Honeywell recommends powering down a unit before connecting hardware to it.
See 2.4.1: Powering Up and Down, p. 2–5.
2–7
PTZ configuration and control are not currently supported in LocalView. PTZ
configuration and control are fully supported when using View software.
2–7
Select a VGA monitor to run LocalView only if the monitor supports a resolution
of 800 × 600.
2–8
Placing a monitor or other equipment directly on top of the Multi-Media unit is
not recommended.
2–8
Do not use re-writable compact discs (CD-RW) or recordable digital video discs
(R-DVD) to store Multi-Media video clips.
2–8
Please make a note of passwords. A lost password can make the LocalView
interface unchangeable.
2–9
The LocalView passwords have no effect on other passwords, set using Admin
software. See the Admin User Guide for procedures involving other passwords.
2–9
Within DHCP without DNS, an assigned IP address needs to be reserved or it
may change.
2–10
Setting an IP address is only needed for a connection to a network. 2–10
A null-modem cable comes with your Multi-Media unit. 2–11