Honeywell RAPID EYE K9696V2 - Manual (Page 5)

Declaration of Conformity
A Rapid Eye Multi-Media LT unit (HRMxxxyyzzzz)
complies with Council Directives 89/336/EEC and
73/23/EEC.
These Euro Norms have been applied:
•
EN50022: 1998, Radio frequency (RF)
emissions;
•
EN50130–4: 1995, Alarm system immunity
with
uninterruptible power supply (UPS);
•
EN60950: 2000, Safety of information
technology equipment;
•
EN61000–3–2: 1995 Harmonics;
•
EN61000–3–3: 1995, Voltage fluctuations
(flicker).
FCC CFR 47, Part 15, Class B
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses, and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
•
reorient or relocate the receiving antenna
•
increase the separation between the
equipment and receiver
•
connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected
•
consult the dealer or a radio/TV technician
for help.
FCC Part 68
This equipment complies with Part 68 of the FCC
rules. On the front cover of this equipment is a
label that contains the FCC registration number
and Ringer Equivalence Number (REN). You must
provide this information to the telephone
company when requested.
This equipment uses a USOC jack: RJ11.
This equipment may not be used on telephone-
company-provided coin service. Connection to
party lines is subject to state tariffs. This
equipment is hearing aid compatible.
Ringer Equivalence Number
A Ringer Equivalence Number (REN) assigned
to each terminal device provides an indication of
the maximum number of terminals allowed to be
connected to a telephone interface. The
termination on an interface may consist of any
combination of devices subject only to the
requirement that the sum of the Ringer
Equivalence Numbers of all the devices does not
exceed 5.
Industry Canada
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de classe B est conforme
à la norme NMB-003 du Canada.
NOTICE: This equipment meets
telecommunications network protective,
operational and safety requirements as
prescribed in the appropriate Terminal Equipment
Technical Requirements document(s). This is
confirmed by marking the equipment with the
Industry Canada certification number. The
Department does not guarantee the equipment
will operate to the user’s satisfaction.
Before installing this equipment, users should
ensure that it is permissible to be connected to
the facilities of the local telecommunications
company. The equipment must also be installed
using an acceptable method of connection. The
customer should be aware that compliance with
the above conditions may not prevent
degradation of service in some situations.
Repairs to certified equipment should be
coordinated by a representative designated by
the supplier. Any repairs or alterations made by
the user to this equipment, or equipment
malfunctions, may give the telecommunications
company to request the user to disconnect the
equipment.
Users should ensure for their own protection that
the electrical ground connections of the power
utility, telephone lines and internal metallic water
pipe system, if present, are connected together.
This precaution may be particularly important in
rural areas.
CAUTION: Users should not attempt to make
such connections themselves but should contact
appropriate electric inspection authority, or
electrician, as appropriate.