Honeywell RAPID EYE K9696V2 - Manual (Page 31)

Field Work
2–13
Table 6
Commands for launching HyperTerminal
Windows Click [Start] and point to … … then click
98 Programs, Accessories, Communications,
HyperTerminal Hypertrm.exe icon
NT Programs, Accessories, HyperTerminal HyperTerminal
2000 Start, Programs, Accessories, Communications HyperTerminal
XP:
XP style Start, All Programs, Accessories,
Communications HyperTerminal
XP:
classic style Start, Programs, Accessories, Communications HyperTerminal
Table 7
Settings for HyperTerminal communications session
Parameter Value
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control Hardware
!22 To use the Multi-Media Shell
1. While watching the terminal program running on the PC, turn the Multi-Media
unit on. For ten seconds, the terminal program displays: “ HIT ENTER TO
KEEP SHELL RUNNING ”.
2. Press Enter within ten seconds. After ten seconds, the Multi-Media unit
bypasses the Multi-Media Shell and continues its initialization.
After 10 minutes of inactivity, the Multi-Media Shell times out.
To return to it, turn the Multi-Media unit off, then use procedure 22.
!23 To assign an IP address to the Multi-Media unit
1. Type “ip=” (without the quotation marks) followed by the network address
assigned to the Multi-Media unit by your network administrator. Press Enter.
2. If needed, use “gateway=” and “netmask=” Multi-Media Shell commands to
set them to values assigned by your network administrator. Press Enter after
each command’s data.