HP STORAGEWORKS XP24000 - Manual (Page 62)

D M=CPU
This command displays the type, the model number, the node ID and the logical partition number
of the host. Write down the information on a paper so that you will not forget it.
For details on the system command, see the documentation for system commands.
2. Ensure that you are in Modify mode.
3. In the Volume Security window ( Figure 4 ), double-click an LDKC number.
4. Right-click Host Group to display a list of host groups.
5. Right-click the host group in which you want to register the host. Next, select Specify and then
Host from the pop-up menu.
The Add/Change Host dialog box (
Figure 11 ) appears.
6. Use the text boxes and the drop-down list to specify information about the host you want to register;
you have already obtained the information earlier in this procedure (see step 1).
7. Click Add.
The specified host is added to the table and is indicated by the icon .
8. Click OK.
CAUTION:
Here, the settings in the window have not been applied to the storage system.
9. Click Apply in the Volume Security window ( Figure 4 ).
A message appears and asks if you want to apply the settings to the storage system.
10. Click Yes.
The settings are applied to the storage system.
TIP:
•
If you registered a host in an incorrect host group, first you must follow the above procedure to
register the host in the correct host group. Then, you must follow the procedure in section
“
Deleting Hosts from Host Groups ” on page 62 to remove the host from the incorrect host group.
•
You can modify information about hosts indicated by in the Add/Change Host dialog box
( Figure 11 ). To modify information, first select the desired host in the table and then use text boxes
and/or drop down list to change information. Next, click Change and then OK. Finally, click
Apply in the Volume Security window (
Figure 4 ).
•
To delete a host indicated by from the Add/Change Host dialog box ( Figure 11 ), you must
first select and right-click the host, select Delete from the pop-up menu, and then select OK. Finally,
click Apply in the Volume Security window (
Figure 4 ).
Deleting Hosts from Host Groups
To delete hosts from a host group, take the following steps:
To delete hosts from a host group:
1. Ensure that you are in Modify mode.
2. In the Volume Security window ( Figure 4 ), double-click an LDKC number.
Performing Volume Security Operations 62