HP 24SII - Manual (Page 27)

If using an IBM PC or compatible to configure the Model 24SII DES,
first make a copy of the BayTech supplied support software disk and
store the original in a safe place. (Refer to your DOS manual for copy
instructions). You will be using the TERM program created by running
the INSTALL program (see
Section 4.2 ) to change the default
configuration of the Model 24SII DES. Any terminal emulation
program supplied by another manufacturer may also be used. Make
sure your PC is connected to Port 1 of Module 1 with the appropriate
serial cable. Use the following procedure:
1. From the BAYTECH subdirectory prompt enter:
a:\term
The program will respond with an identification block
and then a configuration menu for the PC COM port.
!"
!# $ %! %! &! && &%
' ( )
You are now in the terminal emulation mode with full
duplex communication. Any characters you type from
the keyboard will be transmitted out of the PC COM port
to the Model 24SII DES. They will not appear on the
CRT screen. Any characters received from the Model
24SII DES by the PC COM port will be displayed on the
CRT screen.
2. Ensure the displayed PC Configuration is correct. If not,
enter ALT-C to change. For example, if you have your
serial cable physically connected to COM2 on your PC,
first type ALT-C followed by the up arrow key and then
ENTER to have the TERM program switch to COM2.