HP 24SII - Manual (Page 120)

A.7 MODULAR CABLING USING M24SII-V07
I/O MODULE
A.7.1 RJ-45 (8-WIRE) CABLING
NOTE: If you have configured a port on the M24SII-V07 I/O module
to use EIA-232 Protocol and 8-wire Operation, please refer to
Appendix A.5 for recommended adapter/cabling information.
If you have configured a port on the M24SII-V07 module to use EIA-
422 Protocol, 8-wire Operation, and you are not connecting this port
to another BayTech product, please see
Figure 9 in Section 5.5.1 for
a recommended cabling diagram.
If you are connecting another BayTech device (such as Tran-x) to a
port on the M24SII-V07 module as described, an RJ-45 crossed cable
is required to connect the two devices as shown in
Figure 18 below.
NOTE: Before connecting a Tran-x device to the M24SII-V07 module
using this configuration, you must make sure the Tran-x has been
configured to use 8-wire Operation. Please see the Tran-x Operator's
Manual for instructions.
1
2
3
4
5
6
7
8 8
7
6
5
4
3
2
PIN
RJ-45 RJ-45
PIN
1
Figure 18 ++ "! 1
(23(#( *#( $
-