HP 2240 - Manual (Page 95)

5-2
This chapter contains information to help you determine what’s
wrong with your system when you have problems. If you have a
problem that isn’t listed in this chapter, or if your problem persists,
contact your designated service representative. When calling for ser-
vice, always have your system’s model number and serial number
ready.
The instructions in this chapter assume you are using the HP-UX
version 10.20 or later operating system with the HP VUE version 3.0
graphical interface. If your system is configured with the HP CDE
graphical user interface, use command line options in a terminal win-
dow to perform tests.
NOTICE: The J282/2240 power supply draws about 50
Watts in standby mode(system off) and will
turn on a fan when required to cool the supply.
NOTICE: The J282/2240 fan failure circuitry requires that
the power cord must be disconnected for 30
seconds after any fan failure.