HP 2240 - Manual (Page 128)

B-10
Your workstation can have any two of the following removable media
devices, with no two the same:
•
CD-ROM drive
•
2 to 8 GB, 4 mm DDS tape drive
•
3.5-inch Floppy disk drive
Follow these steps for installing any of the removable media drives
into the Storage Assembly. The steps for checking and setting drive
jumpers are different for each drive. Jumper information for each
drive is included in these steps.
NOTICE: Before opening the system unit, follow the
instructions in “Checking the SCSI IDs,” earlier
in this appendix, to determine the SCSI IDs
currently in use on your workstation.
1.
Open the system unit according to the directions in “Opening the
System Unit,” earlier in this appendix.
2. Unscrew the two captive screws on the left side of the Storage
Assembly and pull down the drawer ejector handle on the right
side of the Storage Assembly, as shown in Figure B–3.
The Storage Assembly slides partway out of the drawer.
Installing
Removable
Media Devices