HP 2240 - Manual (Page 232)

D-21
To set the monitor type for graphics(0) to monitor type 2, enter the
following:
Configuration Menu: Enter command >monitor graphics(0) 2
This will take effect on the next reboot.
MONITOR INFORMATION
Path Slot Head HPA Resolution Freq Type Class
––––– –––– –––– ––––– –––––––––– –––– –––– –––––
GRAPHICS(0) 0 1 f8000000 1280x1024 72Hz 2
The boot console displays a message that tells you that your new
monitor selection will take affect the next time you reboot your sys-
tem. The boot console also displays the new monitor information.
Trying to change the monitor type to a number not listed for that
graphics device fails and gives you the following warning message:
Value of monitor type n out of range (n – nn)
Trying to change the monitor type on an empty slot fails and gives
you the following warning message:
No such graphics card.