HP 2240 - Manual (Page 161)

B-43
10. Place the DIMM in the connector, lining it up with the guides.
Make sure to put the notched end toward the white ejector han-
dle (to the left).
Press down on ejector tabs to open them and place
Press DIMM down slightly
Push the DIMM firmly and evenly
Ejector tabs pop partly back up.
Push ejector tabs until they lock
Notched end
the DIMM in the connector so that the fingure is on
the edge of the DIMM just touch the connector.
Close the ejector tabs.
into the connector to be sure it
is properly seated.
in place.
Close the ejector tabs.
Figure B–25.Installing Memory Cards
11. Close the ejector tab.
12.
Press firmly and evenly on the DIMM to ensure that it seats
properly.
13. To replace the CPU Assembly in the system unit, first align the
top of the CPU Assembly with the guide on the system unit. Re-
fer to Figure B–26 and to the label on the back of the assembly.
Be sure to support the CPU Assembly properly while replacing
it.