HP 2240 - Manual (Page 93)

4-12
Configuring the Floppy Driver
If you reload software or rebuild the Instant Ignition system on your
workstation, you need to reconfigure the HP-UX Kernel to add the
floppy driver. Use the SAM utility to add the SCSI flexible disk driv-
er and build a new HP-UX kernel.
For more information about how to reconfigure the kernel using
SAM, see the following manuals:
•
System Administration Tasks HP 9000 Series 700 Computers
(B2355–90040)
•
Using HP-UX (B2910–90001)
Troubleshooting
If you have trouble with any of these procedures for using your
floppy disk drive, see Chapter 5 of this book, “Solving Problems.”
Ordering Information
To order Hewlett-Packard micro flexible diskettes for use in your
3.5-inch floppy disk drive, use the following order number:
HP–92192X High-Density Micro Flexible Disks
(1.44MB Formatted Capacity) – box
of ten diskettes