Intercharacter delay, User specified intercharacter delay – Hand Held Products 2020 User Manual
Page 83
4 - 5
Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed between the
transmission of each character of scanned data. Scan the Intercharacter Delay
barcode below, then scan the number of milliseconds and the SAVE barcode
using the
inside the back cover of this manual.
To remove this delay, scan the Intercharacter Delay barcode, then set the
number of steps to 0. Scan the SAVE barcode using the
inside the back cover of this manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 495 milliseconds may be placed after the
transmission of a particular character of scanned data. Scan the Delay Length
barcode below, then scan the number of milliseconds and the SAVE barcode
using the
inside the back cover of this manual.
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value
for the ASCII character that will trigger the delay
ASCII Conversion Chart (Code
Page 1252)
on page A-2.
To remove this delay, scan the Delay Length barcode, and set the number of
steps to 0. Scan the SAVE barcode using the
inside the
back cover of this manual.
1
2
3
4
5
Intercharacter Delay
Prefix
Scanned Data
Suffix
Intercharacter Delay
Delay Length
Character to Trigger Delay