Utilities, To add a test code i.d. prefix to all symbologies, Reset image scanner – Hand Held Products 2020 User Manual
Page 133: Show software revision, Show data format, Software revision, Chapter 8 - utilities
8 - 1
8
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the Symbology Chart, included in the
Appendix
A
, page A-1) for the single character code that identifies each symbology.) This
action first clears all current prefixes, then programs a Code I.D. prefix for all
symbologies. This is a temporary setting that will be removed when the unit is
reset. For instructions on how to reset your image scanner, refer to
Reset Image Scanner
Scanning this barcode causes the image scanner to re-link with the base.
Show Software Revision
Scan the barcode below to output the current software revision, unit serial
number, and other product information for both the image scanner and base.
Show Data Format
Scan the barcode below to show current data format settings.
Add Code I.D. Prefix to
All Symbologies (Temporary)
Reset Imager
Show Revision
Data Format Settings