Number of beeps - good read, Good read delay, User-specified good read delay – Hand Held Products 2020 User Manual
Page 67: Number of beeps – good read -3, Good read delay -3, User-specified good read delay -3, Number of beeps – good read
3 - 3
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same
number of beeps will be applied to the beeper and LED in response to a good
read. For example, if you program this option to have five beeps, there will be
five beeps and five LED flashes in response to a good read. The beeps and LED
flashes are in sync with one another. To change the number of beeps, scan the
barcode below and then scan a digit (1-9) barcode and the Save barcode on the
inside the back cover of this manual.
Default = One.
Good Read Delay
This sets the minimum amount of time before the image scanner can read
another barcode.
Default = 0 ms (No Delay.
)
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the barcode
below, then set the delay (from 0-30,000 milliseconds) by scanning digits from
the inside back cover, then scanning
Save
.
Number of Beeps/LED Flashes
* No Delay
Short Delay (500 ms)
Medium Delay (1000 ms)
Long Delay (1500 ms)
User-Specified Good Read Delay