Temporary visual xpress configuration, Application work groups -3, Temporary visual xpress configuration -3 – Hand Held Products 2020 User Manual
Page 135
8 - 3
Note: Scanning this barcode also causes both the image scanner and the base
to perform a reset and become unlinked. Refer to
on page 1-6 for additional information.
Resetting the Standard Product Default Settings: All
Application Work Groups
The following barcode defaults all of the work groups to the factory settings.
starting on page 10-6 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the
programming pages).
Temporary Visual Xpress Configuration
For quick download communication configuration, scan the Visual Xpress
barcode to temporarily configure the imager for Visual Xpress settings. Refer to
on page 9-1 for additional information about Visual Xpress.
Note: Connect the imager using RS-232 cables. Scan the barcode below and
the unit will communicate in RS-232 mode, allowing it to work with Visual
Xpress. The imager reverts to the original or reprogrammed interface
when the power is cycled.
Note: If you download new software into a unit, the user-programmed
parameters are retained. If you need to discard user-programmed
settings, scan the Standard Product Default Settings barcode (see
Resetting the Standard Product Default Settings: Current Application
Work Group
Standard Product Default Settings:
Current Application Group
Standard Product Default Settings:
All Application Groups
Visual Xpress