Thermador Masterpiece Series 36 Inch Induction Smart Cooktop Use and Care Guide - Manual (Page 25)

Home Connect™ en-us
25
3.
Follow the instructions in the Home Connect™ app.
7.2 Overview of the Home Connect™ settings
You can adjust the settings and network settings for Home Connect™ in the basic settings for your appliance.
Setting Selection or display Description and additional information
⁠ – Not connected/disconnect network
– Connect automatically
– Connect manually
– Connected
Log the appliance on in the home network (Wi-Fi) or dis-
connect from the network.
⁠ – Not connected
– Connect
Connecting to the app
The setting is only displayed if the appliance is connected
to the home network.
⁠ – Wireless module switched off
– Wireless module switched on
Connection to the (Wi-Fi)
If (Wi-Fi) has been activated, you can use the Home Con-
nect™ functions.
In networked standby mode, your appliance requires a
maximum of 2 W.
The setting is only displayed if the appliance has been pre-
viously connected to a network.
⁠ – Switched off
– Switched on 1
Set using the app
If the setting is switched off, only the cooktop's operating
statuses will be displayed in the Home Connect™ app.
⁠ – Update available and ready for instal-
lation
– Start installation starten
Software update
The setting is only displayed if a software update is avail-
able.
⁠ – Not authorized
– Authorized
Controlling remote access by Customer Support
The setting is only displayed if after-sales service is at-
tempting to connect to the appliance. You can end this at
any time after granting access.
⁠ – Not connected to the home network
(Wi-Fi)
– Signal strength 1 (poor)
– Signal strength 2 (moderate)
– Signal strength 3 (good)
Display Wi-Fi signal strength
The setting is only displayed if there is a connection to the
home network (Wi-Fi).
⁠ – Not connected
– Connected
Connection to Home Connect™ server
The setting is only displayed if there is a connection to the
home network (Wi-Fi).
1 Factory setting
7.3 Changing settings via the Home Con-
nect™ app
You can use the Home Connect™ app to change the set-
tings for the cooking zones and send them to the cooktop.
Requirements
¡ The appliance is connected to the home network and to
the Home Connect™ app.
¡ In order to set the hob via the app, the basic setting
must be switched on.
¡ The hob is switched on.
1. Select the setting in the Home Connect™ app and send
it to the cooktop.
Follow the instructions in the Home Connect™ app.
2.
If the setting was previously , two steps are required:
‒
If CONFIRM flashes, touch CONFIRM.
‒
If the cooking zone display alternately flashes the old
and new value, select the cooking zone.
3.
If the setting was not previously , the old and new
value alternately flash directly on the cooking zone dis-
play.
‒
To accept the setting for the cooking zone, select the
cooking zone.