EnGenius Technologies EOA7530 - Manual (Page 53)

Apply / Cancel Click Apply to apply the changes or Cancel to discard your changes and return to the
previous settings.
7.3 PPPoE (Point‐to‐Point Protocol over Ethernet)
Select Point to Point Protocol over Ethernet (PPPoE) if your ISP uses a PPPoE connection. Your ISP will
provide you with a username and password. This option is typically used for DSL services. Remove
your PPPoE software from your computer, as it is not needed and will not work with your EOA7530.
Login Specify the user name supplied by your ISP.
Password Specify the password supplied by your ISP.
Service Name Specify the service name supplied by your ISP.
MTU Specify the Maximum Transmit Unit size. It is recommended you accept the default
setting of Auto. Otherwise, packets will be fragmented downstream if the MTU is set
too high or too low, which impacts network performance. In extreme cases, an MTU
setting that is too low can prevent the EOA7530 from establishing some connections.
Authentication Type Select the algorithm used for authentication. Choices are PAP, CHAP, or Auto.
Default is Auto.
Type Select a connection type from the drop‐down menu. Choices are:
• Keep Connection = device connects to the Internet automatically.
• Automatic Connection = device connects to the Internet automatically when the
traffic goes through the Internet and disconnects after a period of idle time
elapses.
• Manual Connection = device connects to the Internet manually.
Idle Timeout If the EOA7530 is configured for Automatic Connection, specify the maximum
amount of time the device can remain idle before disconnecting.
Apply / Cancel Click Apply to apply the changes or Cancel to discard your changes and return to the
52