beautypg.com

Adjusting the tear-off position – Epson 5000 User Manual

Page 84

background image

Adjusting the tear-off position

If the perforation is not aligned with the tear-off edge, adjust
the tear-off position by following the steps below:

1. Make sure the paper is in the tear-off position and the

TEAR

OFF

light is on.

2.

While holding down the

ALT button,

press

the LOAD/EJECT

button to adjust the

tear-off position to a lower position on

the page or press the

LF/FF button to adjust the

tear-off

position to a higher position on the page. The printer

remembers the new tear-off position.

3. Tear off any printed pages.

4.

When you begin printing, the printer automatically feeds the

paper back to the loading position and begins printing.
(You can also manually feed the paper back to the loading
position by pressing the LOAD/EJECT or TEAR OFF button.)

Note:

The printer has a minimum and maximum tear-off position. If

you try to advance the loading position beyond these limits, the
printer beeps and the paper stops moving.

When the paper

reaches

the factory-set tear-off position, the

printer beeps and paper feeding pauses briefly.

Use the

factory

setting as a reference point when adjusting the tear-off position.

Using the Printer

3-19