Epson 5000 - Manual (Page 63)

Multi-part forms
Your printer can print on both single-sheet and continuous
multi- part forms. You can load single-sheet multi-part forms
only in the front paper slot.
You can use multi-part forms of up to four parts (including the
original). Make sure you set the paper-thickness lever to the
proper position. Use only carbonless multi-part forms.
You load multi-part forms the same way as you load single
sheets or continuous paper. For best results with continuous
multi-part forms, it is recommended you use the tractor
installed in the push-tractor position together with the optional
pull tractor.
For details, see “Using Single Sheets” or “Loading continuous
paper with the pull tractor,” earlier in this chapter. Pay special
attention to setting the loading position as described in “Using
micro-feed” in Chapter 3.
Caution:
When printing multi-part forms, make sure the printing
stays entirely within the printable area of the forms. (For
more information on the printable area, see Chapter 7.)
Use four-part multi-part forms only under normal
operating conditions.
Load single-sheet multi-part forms from the front only.
Paper Handling 2-25