Connecting 48 vdc power for poe operation, Connecting 48 vdc power for poe operation -13 – Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 User Manual
Page 47

Connecting 48 Vdc Power for PoE Operation
Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide 3-13
Connecting 48 Vdc Power for PoE Operation
The Matrix N5 (7C105‐P) chassis provides 48 Vdc to connected PDs (powered devices) by
way of its backplane connection to a PoE‐compliant DFE module such as the 4G4285‐49 or
4G4205‐72.
For a Matrix E7 (6C107), Matrix N3 (7C103), and Matrix N7 (7C107) chassis, an optional
external Enterasys Matrix N‐POE Power System is required to support PD connections to
the 4G4285‐49. The power from the Matrix N‐POE Power System is supplied through a
DC power cable connection to the front‐panel 48 Vdc Optional Power connector on the
4G4285‐49.
Refer to the Matrix N‐Series N‐POE Power System Installation Guide to install and connect a
Matrix N‐POE Power System to the 4G4285‐49.
Warning: The 48 V wire harness contains two fuses, F11 and F29. If a fuse needs to be
replaced, it must be done by service personnel only. The fuse must be replaced with the
same Type and Rated fuse 20 A, 400 VDC.
Advertencia: E arnes del cable de 48V contiene dos fusibles, F11 y F29. Si un fusible
requiere ser reemplazado, debe ser hecho por personal de servicio unicamente. El fusible
debe ser reemplazado por uno del mismo tipo y clasificado como fusible de 20 A,
400 VDC.
Warnhinweis: Im Kabelbaum der 48V Zuleitung befinden sich 2 Sicherungen, F11 und
F29. Die Sicherung darf nur duch Fachpersonal getauscht werden und darf auch nur
durch den gleichen Typ ersetzt werden ( 20A / 400VDC ).
Note: If you are planning to install a PoE-compliant DFE module such as the 4G4285-49 in
a Matrix N3 (7C103) or Matrix N7 (7C107) chassis, install and connect the Matrix N-POE
Power System before connecting to PDs.
Note: When you install the 7H4385-49 in a Matrix N5 chassis
, the
7H4385-49
48 Vdc
Optional Power Input does not support a connection from an external N-POE Power
System. The 48 Vdc power is supplied through the backplane of the N5 chassis from its
own 48 Vdc power modules. If none of these power modules are installed, then there is no
PoE support.