Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 - Manual (Page 46)

Preparing to Install Module into Matrix E7 or N7 Chassis
3-12 Installation
4. Slide the module into the slot until you can engage the top and bottom locking levers.
5. Refer to the Caution note above, then rotate the two levers into the closed position.
6. If the chassis in which the module is installed was powered down for the installation,
turn the power supplies on. Check to see that the module CPU LED settles at solid
green after a few minutes. If the LED does not turn solid green, refer to
Chapter 4 for
troubleshooting details.
Figure 3-3 Installing Module into Matrix N3 or Matrix N5 Chassis (N3 shown)
Caution: In step 5, do not force the locking levers to the point that they touch the face of
the front panel. Forcing the locking levers to this point could damage the module and
chassis.
Precaución: En el paso 5, tenga cuidado de no llevar las palancas de cierre a un punto
en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo y/o el
chasis.
1 Card guides 5 Upper locking tab (shown in closed position)
2 Slot 1 (Top slot is slot 3.) 6 Lower locking tab (shown in closed position)
3 Module card 7 FTM2 and power backplane connectors
4 Metal back panel