Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 - Manual (Page 36)

Installation Site Requirement
3-2 Installation
Installation Site Requirement
The DFE module must be installed in a Matrix E7, N3, N5, or N7 chassis located in a
Restricted Access Location (RAL). This location should only be accessible by people that
have been trained or are technically competent enough to be aware of potential risks of
accessing the hazardous areas of the chassis. Locations such as a locked wiring closet or
locked cabinet meet this requirement.
Unpacking the DFE Module
Unpack the DFE module as follows:
1. Open the box and remove the packing material protecting the DFE module.
2. Verify the contents of the carton as listed in Table 3‐1 .
3. Remove the tape seal on the non‐conductive bag to remove the module.
4. Perform a visual inspection of the module for any signs of physical damage. Contact
Enterasys Networks if there are any signs of damage. Refer to “
Getting Help ” on
page xviii for details.
Warning: Install this module in a Matrix E7, N3, N5, or N7 chassis that has been installed
in a Restricted Access Location only. Access to the equipment by users must be restricted
through the use of a tool or lock and key or other means of security and is controlled by
the authority responsible for the location.
Advertencia: Instalar este modulo en un Matrix E7, N3, N5, o N7 que ha sido localizado
en un lugar de Acceso Restringido. Aceso al equipo debe ser restringido por el
responsable del sitio.
Warnhinweis: Installieren Sie dieses Modul nur in einem E7, N3, N5, oder N7 Chassis,
wenn sich diese in einer zugangsgeschützten Umgebung befinden. Der Bereich zu den
Komponenten sollte durch ein Schloß, einen Schlüssel oder sonstigen Sicherungen
geschützt und durch einen Verantwortlichen kontrolliert werden.
Table 3-1 Contents of DFE Module Carton
Item Quantity
DFE module (either the 4G4285-49 or the 4G4205-72) 1
Installation Guide 1
Customer Release Notes 1