Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 - Manual (Page 90)

Gaining Access to Memory Modules
B-12 Mode Switch Settings and Option Installations
Figure B-8 Installing the DIMM
Installing the Network Expansion Module (NEM)
Refer to Figure B‐9 and proceed as follows:
1. Position the NEM so its front panel is under the edge of the DFE module front panel.
2. Align the two NEM connectors with the main board connectors. Then press straight
down over the two NEM connectors, applying pressure until they are properly
seated.
1 DIMM 3 Connector arms
2 Connector fingers 4 Alignment notches (2)
А
Б
В
Г
Г
В