Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 - Manual (Page 87)

Gaining Access to Memory Modules
Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide B-9
Removing the DRAM SIMM
To remove the DRAM SIMM, refer to Figure B‐5 and proceed as follows.
1. Refer to Figure B‐5 . Push the connector arms away from the DRAM SIMM to release it
from the connector.
2. Remove the DRAM SIMM from the connector.
Figure B-5 Removing the Existing DRAM SIMM
Installing the DRAM SIMM
To install the DRAM SIMM, refer to Figure B‐6 and proceed as follows:
1. With the connector arms set in the open position, insert the DRAM SIMM between the
connector fingers and push the DRAM SIMM into the connector until the tabs on the
two connector arms pull in towards the DRAM SIMM alignment notches.
2. Push the DRAM SIMM further into the connector until the two DRAM SIMM
alignment notches and the tabs on the two connector arms lock the DRAM SIMM into
place.
Note: The ejector arms on this connector are not spring-loaded, so they will remain in the
open position until manually closed.
1 Connector arms 2 Memory module 3 Connector
В
А
А
Б
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.