How to use this guide, Related documents – Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 User Manual
Page 18
How to Use This Guide
xvi About This Guide
How to Use This Guide
This preface provides an overview of this guide and the DFE‐Gold Series manual set, and
a brief summary of each chapter; defines the conventions used in this document; and
instructs how to obtain technical support from Enterasys Networks.
To locate information about various subjects in this guide, refer to the following table:
Related Documents
The manuals listed below can be obtained from the World Wide Web in Adobe Acrobat
Portable Document Format (PDF) at the following site:
•
Enterasys Matrix DFE‐Gold Series Configuration Guide provides information on how to
use the Command Line Interface to set up and manage the DFE modules.
•
Matrix N‐Series N‐POE Power System Installation Guide describes how to implement
PoE and connect to the 48 Vdc Optional Power connector of the DFE module.
•
Cabling Guide provides information on dB loss and cable specifications.
Unlike the Enterasys Matrix DFE‐Gold Series Configuration Guide and the Matrix N‐
Series N‐POE Power System Installation Guide, the Cabling Guide is not listed
alphabetically on the web site. Instead, it is listed under the Overview Guides link.
For...
Refer to
...
An overview of the DFE module
Network requirements that must be met before
installing the DFE module
Instructions to install the DFE module hardware
Troubleshooting installation problems and
diagnosing network/operational problems using the
LANVIEW LEDs in either the RX/TX port status
mode or PoE port status mode
Specifications, environmental requirements, and
physical properties of the 4G4285-49 and
4G4205-72
Appendix A,
Instructions to set the mode switches when
necessary and remove and replace the DRAM
SIMM or DIMM memory
Appendix B,
Overview of Power over Ethernet technology and
how it is implemented in relation to the DFE
modules.
Appendix C,