Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 - Manual (Page 89)

Gaining Access to Memory Modules
Enterasys Matrix DFE-Gold Series PoE Module Hardware Installation Guide B-11
2. Locate the DIMM connector on the main PC board. Refer back to Figure B‐2 for the
DIMM location on the DFE module.
3. Push the connector arms away from the DIMM, as shown in Figure B‐7 , and
simultaneously lift the DIMM enough to release it from the connector fingers.
Figure B-7 Removing the Existing DIMM
4. Rotate the DIMM upwards, then remove it from the connector fingers.
Installing the DIMM
To install a DIMM, refer to Figure B‐8 and proceed as follows:
1. Insert the DIMM down between the connector fingers.
2. Pivot the DIMM downward so the tabs on the connector arms align with the two
DIMM alignment notches. With the two connector arms spread outward, push the
DIMM down between the connector arms. Then release the two connector arms to
lock the DIMM into place.
3. Reinstall the safety cover. Refer to “ Reinstalling the Safety Cover ” on page B‐14 for
instructions.
1 Connector arms 2 DIMM 3 Connector fingers
А
А
Б
В
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.