Figure b‐4 – Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4G4285-49 User Manual
Page 86
Gaining Access to Memory Modules
B-8 Mode Switch Settings and Option Installations
Figure B-4 Removing the Network Expansion Module (NEM
)
2.
Remove the two screws fastening the NEM to the DFE module front panel and
remove the standoff fastening the NEM to the main board. Save the two screws and
standoff for later use to reinstall the NEM.
3.
Lift and remove the NEM off the two main PC board connectors. Now you have
access to the DIMM. To replace the DIMM, proceed to “
1 Coverplate screws (2)
4 Standoff
2 NEM
5 Main PC board
3 DFE module front panel
6 Main board connectors
This manual is related to the following products: