Cobalt Co9992-4ENC-4K-HEVC Software-Defined Broadcast Encoder - Manual (Page 103)

103

SNMP Traps: This allows SNMP traps to be enabled or disabled 5 . You must click the
Reboot button for the changes to take effect (image shown below).

Enable Parameter Blast: This feature that speeds up DashBoard startup over high-
latency links (i.e., when the computer running DashBoard has a WAN connection to the
encoder or the frame housing the encoder). This feature requires DashBoard version
8.2 or later.

MIB File Download: The 9992-ENC provides an up-to-date copy of its MIBs. If you
click on the Save button, a zip file with the relevant MIBs will be downloaded to your
computer. This zip file contains the card MIBs, as well as the Ross Video and
openGear MIBs required to compile the card MIBs.
Admin General Statistics Tab
The Admin General Statistics Tab is shown below. It shows the current configuration for the
Card Name, SNMP Traps and Enable Parameter Blast controls.
This tab also includes one additional item, Temperature Alarm, which shows the current state
of the 9992-ENC thermal protection system. The possible values are:

None : There is no temperature alarm and the 9992-ENC is operating normally.

Chassis Door Open: The 9992-ENC has detected that the chassis door is open. The
ventilation fans are built into the chassis door; opening the door disengages the fans and
cuts the airflow. While the 9992-ENC can operate for short periods of time without this
airflow, such operation is not guaranteed over long periods of time (more than a few
minutes). The 9992-ENC will remain in yellow alarm for as long as the chassis door is
open. Depending on the chassis loading and ambient temperature, operating with the
door open for more than a few minutes can cause the 9992-ENC to overheat and shut
down.

FPGA Temperature Warning: The 9992-ENC has detected that its internal
temperature has exceeded 70 o C. The exact value can be found in the Product Statistics
Tab. While the 9992-ENC can operate indefinitely in this condition without any damage,
it is recommended that the situation be corrected as the thermal operation margin is
reduced.

FPGA Temperature Critical: The 9992-ENC has detected that its internal
temperature has exceeded 80 o C. The exact value can be found in the Product Statistics
Tab. While the 9992-ENC can operate indefinitely in this condition without any damage,
the situation
MUST be corrected immediately. If the internal temperature reaches 85 o C,
the 9992-ENC will shut down without any further notice to protect itself from damage.
5 SNMP is an optional feature in the openGear™ frame controller. The 9992-ENC SNMP functions are only
available if SNMP is licensed in the frame controller.