Canon WFT-R10A Wireless File Transmitter for EOS R5 C & R5 Mirrorless Camera - Manual (Page 144)

Responding to Error Messages
If transmitter errors are displayed on the camera's LCD monitor, refer to the examples of
corrective actions in this section to eliminate the cause of the error. When an error has
occurred, the
〈 〉 lamp on the transmitter blinks and the error code number is shown
on the LCD panel. You can also check error details by accessing [ : WFT settings ] →
[ Error description ] in the menu.
Click the error code number in the following table to jump to the corresponding page.
11 12
21 22 23
41 43 44 45 46 47 48
61 63 64 65 66 67 68 69
71 72 73
81 83
91
11: Connection target not found
If you are using [EOS Utility], is EOS Utility running?
• Start EOS Utility and re-establish the connection ( ).
Are the transmitter and the access point set to use the same encryption key for
authentication?
• This error occurs if the encryption keys do not match when the authentication
method for encryption is set to [ Open system ].
The encryption key is case-sensitive. Make sure to enter the correct encryption key
for authentication on the transmitter by verifying the uppercase and lowercase
letters used in it (
).
12: Connection target not found
Are the target device and access point turned on?
• Turn on the target device and the access point, then wait a while. If a connection still
cannot be established, perform the procedures to establish the connection again.
144