dbx DriveRack VENU360 Loudspeaker Management System - Manual (Page 32)

30
Configuring Processing Module Insert Types
Processing module inserts are indicated in the on-screen configuration
map by brackets at the top of their columns, as shown to the right. There
are two configurable insert slots in the “input” processing chains and one
configurable insert slot in the “mid” (output) processing chains.
Processing Module Inserts
The two input processing insert slots allow the following processing module insert types to be configured:
• Automatic Gain Control
• Backline Delay
• Compressor
• Graphic EQ
• Noise Gate
• Parametric EQ (12-Band with Narrow Notch Capabilities)
• Subharmonic Synth
NOTE: Processing modules of the same type cannot be inserted back-to-back in the input insert slots.
The mid processing insert slot allows the following processing module insert types to be configured:
• Automatic Gain Control
• Compresor
• Fill Delay
• Noise Gate
• Subharmonic Synth