dbx DriveRack VENU360 Loudspeaker Management System User Manual
Page 12
10
The multi-colored threshold LEDs located at the top of the output meters indicate output limiter activity within the
corresponding output channels. The three colored states are:
•
Green
Indicates the signal level is under threshold and no limiting is occurring.
•
Yellow
Indicates the signal level is in the OverEasy
®
region and some minor limiting is occurring. This state is only active
when the Limiter’s “OVER EASY” setting is turned on.
•
Red
Indicates the signal level has exceeded the Limiter’s threshold and full limiting is occurring.
12. COPY/PASTE Buttons
These buttons allow you to copy and paste various parameter settings and processor module types within the VENU360.
See
‘Copying/Pasting Processing Module Settings’ on page 44
‘Configuring Mixers/Routers’ on page
‘Configuring Processing Module Insert Types’ on page 30
for more information on how to use the
copy/paste functions.
13. RTA Button
Pressing this button will enter the RTA module. See
for more information on the RTA.
14. UTILITY Button
Pressing this button enters the Utility menu, where you can get information about the VENU360’s firmware and network
settings and configure global system settings which dictate how the VENU360 operates. See
for information on the options and parameters available in the Utility menu.
15. MIX/ROUTE MUTE Buttons
Pressing each of these buttons will enable/disable the “MASTER MUTE” parameter inside each corresponding input
Mixer/Router module. When enabled, the signal will be muted prior to the front-panel meters (see
to see a diagram of the signal flow). The state of these mutes are stored with presets.
16. OUTPUT MUTE Buttons
Pressing each of these buttons will mute the corresponding output channel prior to the limiters and output meters (see
‘DSP Block Diagram’ on page 118
to see a diagram of the signal flow). The state of these mutes are global and
are not stored to presets. However, by default, the state of these buttons will be retained after a power cycle.
The MUTES POWERUP function, available in the Utility menu, lets you configure the VENU360 to always power on with
all outputs muted. See
‘Mutes Powerup’
under
for more information on this feature.
You can also press and hold any MUTE button upon power up to force the VENU360 to initialize with all outputs muted,
see
‘Initialize With Mutes On’ on page 96
for more information on this feature.
NOTE:
All output MUTE buttons are automatically enabled when recalling a preset, applying configuration changes,
and after running the Setup Wizard. This is a safety feature. When you’re ready to audition or use the system, simply
unmute the output channels.