dbx DriveRack VENU360 Loudspeaker Management System - Manual (Page 102)

100
Application 2: Full Range Mains + Subs
This application is suited for use with a system consisting of two full range main speakers and subs. The last two available
outputs can be configured for zone, delay fill, or stage monitor use if required.
Application Notes:
• Make sure your mixer and amplifiers (or powered speakers) are turned off before making connections.
• Make connections as described in
‘Making Connections’ on page 4 then apply power to the system according
to the instructions described in ‘Applying Power’ on page 4 .
• Press the WIZARD button then run the Setup Wizard and follow the on-screen instructions. Or, if you know your
speakers and amps aren’t listed in the Setup Wizard, you can simply load preset 78 and start from there.
• Note that some manual configuration changes may be necessary when using the remaining outputs for zone or delay
fill use. See ‘Using Configuration Mode’ on page 24 for further information on making manual configuration
changes in the VENU360.
1
2
1
2
Main Amp
1
2
1
2
Sub Amp
1
2
1
2
Zone, Delay Fill, or Monitor 1-2 Amp
or or
R L
Wireless Router
Left Sub Speaker Right Sub Speaker
Left Main Speaker Right Main Speaker
Windows ® or Mac ®
Computer
iOS ® or Android™
Tablet
or
or
Zone, Delay Fill,
or Monitor 2
Zone, Delay Fill,
or Monitor 1
LEGEND
Left Channel L
R
Right Channel
Center Channel C
Aux Channel A
Channel 1 1
2
Channel 2
Ethernet Connection
Wi-Fi Signal Analog Audio Connection
Optional
Mixer