Sony MAS-A100 IP-Based Ceiling Beamforming Microphone - Manual (Page 95)

95
Additional Inf
orma
tion
• Keep the SD card out of reach of small
children to prevent them from accidentally
swallow the card.
• While “Accessing,” “Saving...,” or “Please
Wait” is displayed on the display window of
the linear PCM recorder, do not remove the
SD card from the recorder. Doing so may
corrupt the data.
• Not all compatible SD cards are assured for
operation with the linear PCM recorder.
• Read-only memory cards, SD cards
protected against accidental erasure, and
write-disabled SD cards are not available for
use with the linear PCM recorder.
• The data stored on the SD card may be
corrupted if:
– you remove the SD card from the linear
PCM recorder or turn off the recorder
while access to the data is in progress.
– you use the SD card in a place subject to
static electricity or electrical noise.
• Be advised that Sony assume no liability for
corruption or loss of your data.
• We recommend that you make a backup
copy of your valuable data.
• Keep your hand or any metal object away
from the terminals on the SD card.
• Keep the SD card against shock hazards and
do not bend or drop the SD card.
• Keep the SD card out of water.
• Do not use the SD card in a place that is:
– not fit the use conditions (inside a closed
vehicle parked under the blazing sun or in
summertime, near a heat source, etc.).
– subject to extreme humidity or corrosive
material.
• Before inserting the SD card, make sure that
is in the correct orientation.
• Do not attach a label on the SD card. Doing
so may cause the SD card stuck in the SD
card slot.
Notes on the Bluetooth function
• Bluetooth wireless technology allows
connection at a distance of up to about 10 m
(33 ft). However, the effective range may
vary depending on obstructions (people,
metals, walls, etc.) or signal status.
• Because Bluetooth and wireless LAN
(IEEE802.11b/g) devices use the same
frequency (2.4 GHz), signal interference may
occur, resulting in communication speed
decrease, noise, or inability to connect, if
Bluetooth communications are used near a
wireless LAN device. In such cases, take the
following measures.
– Perform Bluetooth communications at
least 10 m (33 ft) away from the wireless
LAN device when connecting your linear
PCM recorder and a Bluetooth device.
– Place your linear PCM recorder and the
Bluetooth device as close together as
possible.
– Turn off the wireless LAN device when
performing Bluetooth communications
within about 10 m (33 ft) of a wireless LAN
device.
• Radio waves emitted from a Bluetooth
device may affect the operation of
equipment such as electronic medical
devices. Turn off your linear PCM recorder
and other Bluetooth devices in the following
locations as failure to do so may cause an
accident.
– In hospitals, near priority seats on trains,
in airplanes, in places such as gasoline
stations where flammable gases are
present, near automatic doors or fire
alarms.