Sony MAS-A100 IP-Based Ceiling Beamforming Microphone - Manual (Page 81)

81
Troubleshoo
ting
Bluetooth audio device
Symptom Cause/Solution
You cannot make device registration
(pairing) between the linear PCM
recorder and a Bluetooth audio
device. • The linear PCM recorder and the Bluetooth audio device are too
apart from each other. Bring them closer (within 1 m (3 ft) from
each other) and try it once again.
You cannot establish a Bluetooth
connection. • The linear PCM recorder and the Bluetooth audio device are
turned off. Turn on the linear PCM recorder and the Bluetooth
audio device, and then make sure that the Bluetooth function
is turned on.
• The battery of the linear PCM recorder is running low or almost
out of power. Replace the batteries with new ones.
• The device registration (pairing) information is cleared in the
following cases. You need to register (pair) the device with your
linear PCM recorder once again.
– The settings on either or both devices are reset to the default
settings, for example, due to initialization.
– The device registration (pairing) information is deleted, for
example, during the course of a repair service.
If the device registration (pairing) is deleted from the linear PCM
recorder but the Bluetooth audio device still has the device
registration (pairing) information of the linear PCM recorder,
delete the information and make device registration (pairing)
once again.
• The linear PCM recorder and the Bluetooth audio device are
too apart from each other. When the linear PCM recorder and
the Bluetooth audio device are separated by a long distance,
an attempt to establish a Bluetooth connection may fail or the
established Bluetooth connection may be disconnected. Use
them in a close vicinity.