Sony Planar T* FE 50mm f/1.4 ZA Lens - Manual (Page 35)

35
Time Code
Press the button to display the time code. You
can set the time code under “Time Code”
(page 33).
Quad View
Press the button to display four inputs on the
screen.
WFM
Press the button to display WFM (Wave Form
Monitor).
Vector
Press the button to display Vector (vector scope).
ALM
Press the button to display the audio level meter.
Pixel Zoom
Press the button to use the pixel zoom.
Black Detail High
Press the button to accurately display dark
scenes. Use this when setting a higher range for
the brightness of the display.
Black Detail Mid.
Press the button to accurately display dark
scenes.
Black Detail Low
Press the button to accurately display dark
scenes. Use this when setting a lower range for
the brightness of the display.
Dynamic Cont. Dr.
Press the button to check the balance between
bright and dark scenes.
Under Scan
Press the button to display an image 3% smaller
than the image displayed with scaling (Native
Scan Off).
Notes
 The “Black Detail High” to “Black Detail Low”
functions and “Dynamic Cont. Dr.” cannot be
used simultaneously.
 When “Under Scan” is set to “On,” “Native
Scan” is set to “Off.”
 Some functions are not available in Quad View.
For details, refer to “Quad View Functions and
Adjustable/Setting Items” (page 12).
Remote menu
You can configure the settings for connecting to
an external device that controls the monitor
remotely.
Monitor Network
Controller Network
Submenu Setting
Connection Set the connection to an external
device.
 Off: Set to Off when this unit is not
controlled remotely.
 Peer to Peer: for one to one
connection
 LAN: for connection via a network
Network Setting
Monitor ID Sets the ID of this unit.
Group ID Sets the group ID of this unit.
IP Address Sets the IP address.
Subnet Mask Sets the subnet mask.
Default Gateway Sets the default gateway On or Off.
 Address: Sets the default gateway.
Cancel Selects to cancel the setting.
Confirm Selects to save the setting.