Sony Planar T* FE 50mm f/1.4 ZA Lens - Manual (Page 26)

26
 Color: Sets the color of the aspect
marker.
 White (white)
 Red (red)
 Green (green)
 Blue (blue)
 Yellow (yellow)
 Cyan (cyan)
 Magenta (magenta)
 Intensity: Sets the luminance of the
aspect marker.
 High (bright)
 Low (dark)
 Blanking: Sets the blanking outside
the area of the aspect marker.
 Off: Blanking is released.
 Black: Sets blanking.
 Half: Sets half blanking.
Center Marker Sets whether to display the center
marker (Off or On).
 Type: Sets the type of the center
marker.
 Type1
 Type2
 Type3
 Color: Sets the color of the center
marker.
 White (white)
 Red (red)
 Green (green)
 Blue (blue)
 Yellow (yellow)
 Cyan (cyan)
 Magenta (magenta)
 Intensity: Sets the luminance of the
center marker.
 High (bright)
 Low (dark)
Area Marker1
Area Marker2 Sets whether to display (Off or On)
area marker 1 and area marker 2.
 Area Mode: Sets the type of the area
marker.
 Safe Area
 Flexible Area
Submenu Setting
 Aspect Mode: Sets the aspect ratio
of area marker 1/2 when “Safe
Area” is selected in “Area
Mode.”
 16:9
 15:9
 14:9
 13:9
 4:3
 2.39:1
 2.35:1
 1.85:1
 1.66:1
 1.896:1
 Variable
Note
When “Variable(dots)” is selected in
“Area Size,” the size of area marker 1/2
is set in the pixels of the input signal
and the “Aspect Mode” setting
becomes invalid.
When “Variable” is selected in “Aspect
Mode”
 Aspect: Sets the aspect ratio of area
marker 1/2. Set to 1.00:1 to
3.00:1.
 Area Size: Sets the size of area
marker 1/2 when “Safe Area” is
selected in “Area Mode.”
 80%
 88%
 90%
 93%
 Variable(%)
 Variable(dots)
When “Area Size” is set to
“Variable(%)” or “Variable(dots)”
 Width: Sets the width of area marker
1/2.
Set to 050 to 100% when
“Variable(%)” is selected.
Set to 640 to 4096dots when
“Variable(dots)” is selected. Set
one digit each.
 Height: Sets the height of area
marker 1/2.
Set to 050 to 100% when
“Variable(%)” is selected.
Set to 360 to 2160dots when
“Variable(dots)” is selected. Set
one digit each.
 H Position: Sets the horizontal
position of the marker at the
top left corner of the image
display area as the starting
point when “Flexible Area” is
selected in “Area Mode.” You
can set to a position from 0 to
4095.
Submenu Setting