Sony Planar T* FE 50mm f/1.4 ZA Lens - Manual (Page 3)

3
Precaution
On Safety
 Operate the unit only with a power source as
specified in the “Specifications” section.
 A nameplate indicating operating voltage, etc.,
is located on the rear panel.
 Should any solid object or liquid fall into the
cabinet, unplug the unit and have it checked by
qualified personnel before operating it any
further.
 Do not drop or place heavy objects on the
power cord. If the power cord is damaged, turn
off the power immediately. It is dangerous to
use the unit with a damaged power cord.
 Unplug the unit from the wall outlet if it is not
to be used for several days or more.
 Disconnect the power cord from the AC outlet
by grasping the plug, not by pulling the cord.
 The socket-outlet shall be installed near the
equipment and shall be easily accessible.
On Installation
 Allow adequate air circulation to prevent
internal heat build-up.
Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains,
draperies) that may block the ventilation holes.
 Do not install the unit in a location near heat
sources such as radiators or air ducts, or in a
place subject to direct sunlight, excessive dust,
mechanical vibration or shock.
When installing the installation space must be
secured in consideration of the ventilation and
service operation.
 Do not block the ventilation slots and vents of
the fans.
 Leave a space around the unit for ventilation.
 Leave more than 30 cm of space in the rear of
the unit to secure the operation area.
When the unit is installed on the desk or the like,
leave at least 4.4 cm of space in the left and right
sides, 4.4 cm or more of space above the unit.
On Wiring
 Do not forcibly wire cables and the AC power
cord to the front of the monitor. Doing so may
overload the contact point of a plug.
 When using headphones, do not bring the
headphone cable close to the surface of the
monitor. Depending on the headphones, noise
may occur.
Connecting to Other Devices
When connecting this unit to other devices, turn
off this unit and the other devices beforehand.
Connecting while turned on may cause a
malfunction to this unit and the other devices.
Handling the Screen
 The LCD panel fitted to this unit is
manufactured with high precision technology,
giving a functioning pixel ratio of at least
99.99%. Thus a very small proportion of pixels
may be “stuck”, either always off (black),
always on (red, green, or blue), or flashing. In
addition, over a long period of use, because of
the physical characteristics of the liquid crystal
display, such “stuck” pixels may appear
spontaneously. These problems are not a
malfunction.
 Do not leave the screen facing the sun as it can
damage the screen. Take care when you place
the unit by a window.
 Do not push or scratch the monitor’s screen. Do
not place a heavy object on the monitor’s
screen. This may cause the screen to lose
uniformity.
 Make sure to use the unit without the panel-
guard plate during power distribution.
Otherwise, panel failure may result due to
temperature increase of the panel.
 The screen and the cabinet become warm
during operation. This is not a malfunction.
On the Surface of the Unit
The surface of the unit becomes extremely hot.
Do not touch the surface with your hand or body
during power distribution. It may cause a burn.