Sony Sonnar T* FE 55mm f/1.8 ZA Lens - Manual (Page 28)

28
RGB Range When “RGB/YCC Range Auto” is set to
“Off” and the signal is RGB, select from
the following:
 Full: 0 to 1023 (10bit) / 0 to 4095
(12bit)
 Limited: 64 to 940 (10bit) / 256 to
3760 (12bit)
YCC Range When “RGB/YCC Range Auto” is set to
“Off” and the signal is YCbCr, select
from the following:
 Full: 0 to 1023 (10bit) / 0 to 4095
(12bit)
 Limited: 64 to 940 (10bit) / 256 to
3760 (12bit) (Default value)
Col. Space/Mtx.
Auto Select how to set the color space and
transfer matrix.
 On: Use the color space and transfer
matrix according to the input
signal information.
 Off: Use the color space and transfer
matrix that was set in the menu.
Color Space Select the color space from the
following when “Col. Space/Mtx. Auto”
is set to “Off.”
 ITU-R BT.709
 EBU
 SMPTE-C
 Native 1)
 S-Gamut/S-Gamut3
 S-Gamut3.Cine
 DCI-P3
 ITU-R BT.2020
1) Displays with the unit’s color space
of the three primary color
chromaticity points. This is the
widest color space setting which the
unit can reproduce.
Transfer Matrix Select the transfer matrix from the
following when “Col. Space/Mtx. Auto”
is set to “Off.”
 ITU-R BT.709
 ITU-R BT.2020
Set the following depending on the
“Color Space” setting.
When “ITU-R BT.2020” is selected:
Select ITU-R BT.2020.
When “ITU-R BT.709” is selected:
Select ITU-R BT.709.
When another item is selected: Select
the transfer matrix setting of the
device which outputs the signal.
Submenu Setting
EOTF Select the gamma from the following:
 2.2
 2.4
 2.6
 CRT
 2.4(HDR)
 S-Log3(HDR)
 S-Log2(HDR)
 SMPTE ST 2084(HDR)
 ITU-R BT.2100(HLG)
 S-Log3(Live HDR)
When “ITU-R BT.2100(HLG)” is selected
 HLG System Gamma: Sets the
system gamma of the HLG. Set
from 1.000 to 1.500. (Default
value: 1.200)
User Preset Select the User Preset data to be
applied.
 User Preset1 (Default value)
 User Preset2
 User Preset3
 User Preset4
 User Preset5
 User Preset XYZ
Note
When the XYZ format signal is input,
set to “User Preset XYZ.”
Copy From Copy another input setting data to the
selected input setting.
 Input Setting1 (Default value)
 Input Setting2
 Input Setting3
 Input Setting4
 Input Setting5
 Input Setting6
 Input Setting7
 Input Setting8
Input Setting Skip Sets the skip setting when changing
the input setting with Input select
buttons (page 7) or the controller.
Select “Skip”/“Not Skip” for each input
setting of “Input Setting1” to “Input
Setting8.”
 Skip: Skips.
 Not Skip: Does not skip.
When “Not Skip” is selected, the input
setting changes in sequential order
every time Input select buttons are
pressed.
Submenu Setting