Sony Sonnar T* FE 55mm f/1.8 ZA Lens User Manual
Page 26
26
EOTF Auto
Select how to set EOTF when “Signal
Format” is set to a setting other than
“444 XYZ 12bit.”
On:
Use EOTF according to the input
signal information. When the
value of SDI Payload ID Transfer
characteristics is Unspecified,
EOTF that was set in “EOTF” is
applied. (Default value)
Off:
Use EOTF that was set in “EOTF.”
EOTF
Select the gamma from the following
when “EOTF Auto” is set to “Off.”
2.2
2.4 (Default value)
2.6
CRT
2.4(HDR)
S-Log3(HDR)
S-Log2(HDR)
SMPTE ST 2084(HDR)
ITU-R BT.2100(HLG)
S-Log3(Live HDR)
When “ITU-R BT.2100(HLG)” is selected
HLG System Gamma:
Sets the
system gamma of the HLG. Set
from 1.000 to 1.500. (Default
value: 1.200)
Note
When “Signal Format” is set to “Auto”
or “444 XYZ 12bit” and the XYZ signal is
input, the optimum setting for the XYZ
signal is fixed.
Col. Space/Mtx.
Auto
Select how to set the color space and
transfer matrix when “Signal Format” is
set to a setting other than “444 XYZ
12bit.”
On:
Use the color space and transfer
matrix according to the input
signal information. (Default
value)
Off:
Use the color space and transfer
matrix that was set in the menu.
Submenu
Setting
Color Space
Select the color space from the
following when “Col. Space/Mtx. Auto”
is set to “Off.”
ITU-R BT.709 (Default value)
EBU
SMPTE-C
Native
1)
S-Gamut/S-Gamut3
S-Gamut3.Cine
DCI-P3
ITU-R BT.2020
1) Displays with the unit’s color space
of the three primary color
chromaticity points. This is the
widest color space setting which the
unit can reproduce.
Note
When “Signal Format” is set to “Auto”
or “444 XYZ 12bit” and the XYZ signal is
input, the optimum setting for the XYZ
signal is fixed.
Transfer Matrix
Select the transfer matrix from the
following when “Col. Space/Mtx. Auto”
is set to “Off.”
ITU-R BT.709 (Default value)
ITU-R BT.2020
Set the following depending on the
“Color Space” setting.
When “ITU-R BT.2020” is selected:
Select ITU-R BT.2020.
When “ITU-R BT.709” is selected:
Select ITU-R BT.709.
When another item is selected: Select
the transfer matrix setting of the
device which outputs the signal.
Note
When “Signal Format” is set to “Auto”
or “444 XYZ 12bit” and the XYZ signal is
input, the optimum setting for the XYZ
signal is fixed.
User Preset
Select the User Preset data to be
applied.
User Preset1 (Default value)
User Preset2
User Preset3
User Preset4
User Preset5
User Preset XYZ
Note
When the XYZ format signal is input,
set to “User Preset XYZ.”
Submenu
Setting