Sony E 15mm f/1.4 G Lens - Manual (Page 42)

42
3
Click on [ADCP] to display the ADCP page.
Start ADCP Service: Set ADCP to enabled or
disabled. Items for ADCP are enabled only
when this function is enabled.
-Requires Authentication: Set the
authentication for ADCP to enabled or
disabled. The password is the same as that
of the Web page administrator.
-Port No.: Input the server port of ADCP. The
factory default setting is “53595.”
-Timeout: Input the time (seconds) until ADCP
communication is terminated in case it is
disconnected. The factory default setting is
“60.”
-Host Address: Input the IP address that the
ADCP server is allowed to receive. If no IP
address is input, receiving commands will
be allowed from any IP address. From the
moment the IP address is input, access will
be allowed only from that input IP address.
For security reasons, it is recommended to
input an IP address to restrict access.
4
Click on [PJ Talk] to display the PJ Talk page.
Start PJ Talk Service: Set PJ Talk to enabled or
disabled. Items for PJ Talk are enabled only
when this function is enabled.
-Community: Input the community name of
Advertisement and PJ Talk. If the
community name for PJ Talk is changed,
the one for Advertisement will also be
changed. Only four alphanumeric
characters can be input. The factory default
setting is “SONY.” To avoid unwanted
access to the projector from other
computers, changing the community name
of the factory default is recommended.
-Port No.: Input the server port of PJ Talk. The
factory default setting is “53484.”
-Timeout: Input the time (seconds) until PJ
Talk communication is terminated in case it
is disconnected. The factory default setting
is “30.”
-Host Address: Input the IP address that the
PJ Talk server is allowed to receive. If no IP
address is input, receiving commands will
be allowed from any IP address. From the
moment the IP address is input, access will
be allowed only from that input IP address.
For security reasons, it is recommended to
input an IP address to restrict access.
5
Click on [PJ Link] to display the PJ Link page.
Start PJ Link Service: Set PJ Link to enabled or
disabled. Items for PJ Link are enabled only
when this function is enabled.
-Requires Authentication: Set the
authentication for PJ Link to enabled or
disabled.
-Password: Input the authentication
password for PJ Link.
ADCP button
PJ Talk button
PJ Link button