beautypg.com

The operation menu – Sony E 15mm f/1.4 G Lens User Manual

Page 30

background image

30

The Operation Menu

The Operation menu is used for setting for the operations by using the menu or the Remote Commander.

Setting items

Description

Language

Selects the language used in the menu and on-screen displays.

Menu Position

Bottom Left/Center:

For selecting the position of the menu displayed on the projected

image.

Status

On:

All on-screen statuses are enabled.

Off:

Displays only the menus and warning messages.

All Off:

Turns off the on-screen displays, other than certain menus.

When “All Off” is selected, a warning message for high temperature is not displayed, so
users are advised to use the projector at their own risk.

Note that Sony is not liable for failure of the unit or any accident caused by selecting “All
Off.”

IR Receiver

Front & Rear/Front/Rear:

Selects the remote control receivers (IR Receiver) on the front

and rear of the projector.

ID Mode

All/1/2/3/4:

Assigns an ID number to the projector. When set to “All,” you can control the

projector with the Remote Commander independently of the assigned ID Mode. Refer also
to “ID MODE switch” of the Remote Commander on page 7.

Security Lock

On/Off:

This function enables restriction of the projector to authorized users by password.

The setting procedures for security locking are as follows:

1

Select “On” then press the ENTER key to display the setting menu.

2

Input the password with the MENU,

/

/

/

, and ENTER keys. (The default password

setting is “ENTER, ENTER, ENTER, ENTER.”)

3

Input a new password with the MENU,

/

/

/

, and ENTER keys.

4

Enter the password again to confirm.

Enter the password when you turn on the projector after disconnecting and reconnecting
the AC power cord.
When it is set to “Off,” you can cancel the security lock. You are required to input the
password again.
If you fail to enter the correct password after three consecutive times, the projector cannot
be used. In this case, press the

/

key to go standby mode then turn on the power again.

You will not be able to use the projector if you forget your password. Contact qualified
Sony personnel for further assistance. You are required to inform the projector serial
number and your identity for verification. (This process may differ in other countries/
regions.) Once your identity has been confirmed, we will provide you with the password.

Control Key Lock

On/Off:

When set to “On,” locks all the control keys of the projector. However, you can

enable operation by performing the following even when “Control Key Lock” is set to “On.”

Press and hold the

/

key for approximately 10 seconds during standby mode.

The projector turns on.

Press and hold the MENU key for approximately 10 seconds during power on.

“Control Key Lock” is set to “Off” and enables operation of all control panel keys on
the projector.

Lens Control

On/Off:

When set to “On,” you can adjusts the lens (focus, zoom, and lens shift) from the

Remote commander or the projector. To prevent unintentional operation, set it to “Off”
after adjusting the lens.

Notes

Note