Sony E 15mm f/1.4 G Lens - Manual (Page 41)

41
2
Set the Internet protocol in [Network Setting].
Via HDBaseT: Set the network settings for the
HDBaseT terminal.
LAN port: Set the network settings for the
LAN port.
3
Set the items for Internet protocol.
(a) IPv4/IPv6 address
Obtain an IP address automatically (DHCP):
Automatically provides the IP Address
provided by a DHCP server.
Specify an IP address: Set the network
manually.
-IP Address: Input the IP address of the
projector.
-Prefix: For IPv6, input the prefix (bit) of the
projector.
-Subnet Mask: Input the subnet mask of the
projector.
-Default Gateway: Input the default gateway
of the projector.
(b) DNS server
Auto:
Automatically provides the IP Address
provided by a DHCP server.
Manual
-Primary DNS:
Input the primary DNS server
of the projector.
-Secondary DNS: Input the secondary DNS
server of the projector.
4
Set the items for Ethernet.
MAC Address: Displays the MAC address of
the projector.
Different MAC addresses for the HDBaseT terminal
or LAN port are provided to the projector.
The DHCP server provides different IP addresses/
DNS for the HDBaseT terminal or LAN port.
Change the settings for the control protocol on the
Setup page.
Entered values will not be applied unless you click
on [Apply].
1
Click on [Advanced Menu] to display the Setup
page.
2
Click on [Advertisement] to display the
Advertisement page.
Start Advertisement Service: Set
Advertisement to enabled or disabled.
Items for Advertisement are enabled only
when this function is enabled.
-Community: Input the community name for
Advertisement and PJ Talk. If the
community name for Advertisement is
changed, the one for PJ Talk will also be
changed. Only four alphanumeric
characters can be input. The factory default
setting is “SONY.” To avoid unwanted
access to the projector from other
computers, changing the community name
of the factory default is recommended.
-Port No.: Input the transmit port of
Advertisement. The factory default setting
is “53862.”
-Interval: Input the transmission interval
(seconds) of Advertisement. The factory
default setting is “30.”
-Broadcast Address: Input the destination of
data via Advertisement. If nothing is input,
the data will be broadcast in the same
subnetwork.
Note
Setting the Control Protocol of the Projector
Advanced Menu button
Advertisement button