Sony E 15mm f/1.4 G Lens - Manual (Page 37)

37
Using Network Features
Connection to the network allows you to perform
the following.
Use the projector with only necessary functions
enabled.
 Checking the current status of the projector.
 Remotely controlling the projector.
 Receiving the e-mail report for the projector.
 Making the network settings for the projector.
 Monitoring networks and supporting control
protocol (Advertisement, ADCP, PJ Talk, PJ Link,
SNMP, AMX DDDP [Dynamic Device Discovery
Protocol], Crestron RoomView).
 Using the HTML Viewer Function.
 Setting the time for the HTML viewer.
 Restoring the network settings to their factory
defaults.
 Using the Software Update Function.
 When connecting this projector with the network,
consult with the network administrator. The network
must be secured.
 When using this projector connected with the network,
access the control window via a Web browser and
change the access limitation of the factory preset values
(page 37). It is recommended to change the password
regularly.
 When the setting on the Web browser is completed,
close the Web browser to log out.
 Supported Web browsers are Internet Explorer (version 11
or later), Safari, and Chrome.
 The menu displays only English.
 If the browser of your computer is set to [Use a proxy
server] when you have access to the projector from your
computer, click the check mark to set accessing without
using a proxy server.
 SNMP, AMX DDDP, and Crestron RoomView do not
support IPv6.
 The following menu displays used for the explanation
may be different depending on the model you are using.
1
Connect the LAN cable (page 11).
2
Set the network settings for the projector
using “Network Setting” in the Connection/
Power menu (page 31).
3
Start a Web browser on the computer, enter
the following in the address field, then press
the Enter key on your computer.
http://xxx.xxx.xxx.xxx
(xxx.xxx.xxx.xxx: IP address for the projector)
When connecting with the IPv6 address
http://[xxxx:xxxx:••• xxxx]
You can confirm the IP address of the
projector under “Network Setting” in the
Connection/Power menu (page 31).
The following window appears in the Web
browser.
Once you make the network settings, you can
open the control window only by performing step
3 of this procedure.
Operating the control window
Switching the page
Click one of the Page Switching buttons to display
the desired setting page.
Setting the access limitation
You can limit a user for accessing any particular
page.
Administrator: Allowed access to all pages
User: Allowed access to all pages except the
Setup page
Network Features
Notes
Displaying the Control Window of the
Projector with a Web Browser
Page Switching buttons