Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer - Manual (Page 89)

89
Navi MFX List
Looper
46 DJFX Looper
Loops a short portion of the input sound. You can vary the playback direction and playback speed of the input sound to add turntable-
type effects.
R out
L out L in
R in
Speed
Control Delay Delay
Delay Delay Speed
Control
Speed Speed
Control Control
Speed Speed
Control Control
Delay Delay
Delay Delay
Parameter Value Explanation
Length 230–12 (not straight) Length of the loop
Speed -1.00–+1.00
Playback direction and playback speed.
- direction: Reverse playback
+ direction: Normal playback
0: Stop playback
As the value moves away from 0, the playback speed becomes faster.
Loop Sw OFF, ON
If you turn this on while the sound is heard, the sound at that point will be
looped. Turn this off to cancel the loop.
If the effect is recalled with this ON, this parameter must be turned OFF
and then turned ON again in order to make the loop operate.
Level 0–127 Output Level
47 BPM Looper
Loops a short portion of the input sound. This can automatically turn the loop on/off in synchronization with the rhythm.
R out R out
L out L out
Loop Sw Loop Sw
Control Control
L in L in Delay Delay
Delay Delay R in R in
Parameter Value Explanation
Length 230–12 (not straight) Specifies the length of the loop.
Rate Sync OFF, ON If this is ON, the rate synchronizes with the tempo of the rhythm.
Rate 0.05–10.00 [Hz] Cycle at which the loop automatically turns on/off
Rate Note Note
1/64T, 1/64, 1/32T, 1/32, 1/16T, 1/32., 1/16, 1/8T, 1/16., 1/8, 1/4T, 1/8., 1/4,
1/2T, 1/4., 1/2, 1T, 1/2., 1, 2T, 1., 2
Timing 1–8
Specifies the timing within the cycle at which the loop automatically starts
(which step of the eight timing divisions at which the sound is heard)
Lenth 1–8
Specifies the length at which the loop automatically ends within the cycle
(the number of times that the 1/8-length of sound is heard)