Parameter list (sh-101), Parameter list (sh-101) tone parameters, Navi – Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer User Manual
Page 114
114
Parameter list (SH-101)
TONE Parameters
TONE
TONE
SH-101
SH-101
* You may not be able to obtain the controller effect that you want with tones that use MFX Control.
Parameter
Value
Explanation
OSC
OSC
OSC LFO MOD
0–100
Adjusts the depth at which the LFO modulates the OSC.
OSC RANGE
16’, 8’, 4’, 2’
Specifies the oscillator’s octave.
PULSE WIDTH
MOD
0–127
PW MODE =MANUAL
Adjusts the pulse width value.
PW MODE =LFO/ENV
Adjusts the depth of modulation.
PW MODE
Specifies the pulse width mode.
LFO
The pulse width is affected by the LFO.
MANUAL
The pulse width is affected by PULSE WIDTH MOD.
ENV
The pulse width is affected by ENV.
COMMON
COMMON
Tempo
20.00–300.00
Sets the tempo of the tone (including the arpeggio, motion and sequencer).
BEND PITCH
0–1500
Specifies the range of pitch change produced by pitch bend.
BEND FILTER
-63–0–+63
Specifies the range of filter change produced by pitch bend.
MODULATION
LFO
-63–0–+63
Specifies the amount of LFO applied by modulation.
PORTA MODE
Turns portamento on/off. If this is on, the pitch will change smoothly from one note to the next-played
note.
OFF
Regardless of the portamento time setting, portamento is not applied.
ON
Portamento is always applied.
AUTO
Portamento is applied only when you play legato (pressing the next key before
completely releasing the previously-played key). This lets you use your playing
technique to control portamento on/off.
PORTA TIME
0–1023
Adjusts the time over which the portamento pitch change occurs.
PORTA CRV
Specifies the pitch change curve for portamento.
ORIGINAL
Change according to the original curve of the model.
LINEAR
Change on a linear curve.
EXP1
Change in a non-linear curve (gentle slope).
EXP2
Change in a non-linear curve (steep slope).
KEY MODE
Specifies how notes are sounded.
POLY
Polyphonic
SOLO
Monophonic
UNISON
Unison
SL-UNISON
Monophonic unison
AFT LFO
-63–+63
Sets how much aftertouch changes the LFO intensity.
* This is only enabled for products with aftertouch.
AFT FREQ
-63–+63
Sets how much aftertouch changes the low-pass filter intensity.
* This is only enabled for keyboards with aftertouch.
AFT LEVEL
-63–+63
Sets how much aftertouch changes the tone volume.
* This is only enabled for keyboards with aftertouch.