Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer - Manual (Page 105)

105
Navi
MASTER EFFECTS
Parameter Value Explanation
MASTER EQ MASTER EQ
Switch OFF, ON
Specifies whether the mastering EQ (an equalizer applied to the entire sound
generator of the GAIA-2) is used (ON) or not used (OFF).
In Gain -24–+24 [dB] Adjusts the amount of boost/cut for the input to the EQ.
Low Freq 20–16000 [Hz] Frequency of the low range.
Low Gain -24–+24 [dB] Gain of the low range.
Mid1 Freq 20–16000 [Hz] Frequency of the middle range 1.
Mid1 Q
0.5, 1.0, 2.0, 4.0, 8.0,
16.0
Width of the middle frequency range 1. Set a higher value for Q to narrow
the range to be affected.
Mid1 Gain -24–+24 [dB] Gain of the middle frequency range 1.
Mid2 Freq 20–16000 [Hz] Frequency of the middle range 2.
Mid2 Q
0.5, 1.0, 2.0, 4.0, 8.0,
16.0
Width of the middle frequency range 2. Set a higher value for Q to narrow
the range to be affected.
Mid2 Gain -24–+24 [dB] Gain of the middle frequency range 2.
Mid3 Freq 20–16000 [Hz] Frequency of the middle range 3.
Mid3 Q
0.5, 1.0, 2.0, 4.0, 8.0,
16.0
Width of the middle frequency range 3. Set a higher value for Q to narrow
the range to be affected.
Mid3 Gain -24–+24 [dB] Gain of the middle frequency range 3.
High Freq 20–16000 [Hz] Frequency of the high range.
High Gain -24–+24 [dB] Gain of the high range
MASTER COMP MASTER COMP
Switch OFF, ON
Specifies whether the mastering COMP (a compressor applied to the entire
sound generator of the GAIA-2) is used (ON) or not used (OFF).
Low Attack 0.1–100 [ms]
Specifies the time from when the input exceeds Low Thres until compression
is applied to the volume of the low-frequency band.
Low Rels 10–1000 [ms]
In a state when compression is already being applied, this specifies the time
from when the input decreases below Low Thres until the low-frequency
band stops being compressed.
Low Thres -60–0 [dB]
Specifies the volume level at which compression starts for the low-frequency
band.
Low Ratio
1:1, 2:1, 3:1, 4:1, 8:1,
16:1, 32:1, INF:1
Specifies the compression ratio for the low-frequency band.
Low Knee 0–30 [dB]
This function smooths out the sonic transition, from when the compression
is not engaged until when the compression begins. This gradually applies
compression from just before the Low Thres point. Higher values produce a
smoother transition.
Low Gain -24–+24 [dB] Specifies the output volume of the low-frequency band.
Mid Attack 0.1–100 [ms]
Specifies the time from when the input exceeds Mid Thres until compression
is applied to the volume of the mid-frequency band.
Mid Rels 10–1000 [ms]
In a state when compression is already being applied, this specifies the time
from when the input decreases below Mid Thres until the mid-frequency
band stops being compressed.
Mid Thres -60–0 [dB]
Specifies the volume level at which compression starts for the mid-frequency
band.