Roland GAIA 2 37-Key Virtual Analog + Wavetable Synthesizer - Manual (Page 76)

76
Navi MFX List
31 Saturator
This effect combines overdrive and filter.
Balance W
Balance D
Balance D
Pre Pre
Filter Filter
Overdrive Overdrive
Post Post
Filter1-3 Filter1-3
Pre Pre
Filter Filter
Overdrive Overdrive
Post Post
Filter1-3 Filter1-3
L in L in L out L out
R out R out R in R in
Parameter Value Explanation
Pre Type THRU, LPF, HPF, LSV, HSV
The types of filters available before distortion processing.
THRU: No filter is applied
LPF: A filter that passes the sound below the specified frequency
HPF: A filter that passes the sound above the specified frequency
LSV: A filter that boosts/cuts the sound below the specified frequency
HSV: A filter that boosts/cuts the sound above the specified frequency
Pre Freq 20–16000 [Hz] Frequency at which the pre-distortion filter operates
Pre Gain -24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Drive 0.0–48.0 [dB] Strength of distortion
Post1 Type THRU, LPF, HPF, LSV, HSV Type of filter 1 which follows the distortion processing
Post1Frq 20–16000 [Hz] Frequency at which post-distortion filter 1 operates
Post1Gain -24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Post2 Type THRU, LPF, HPF, LSV, HSV Type of filter 2 which follows the distortion processing
Post2Frq 20–16000 [Hz] Frequency at which post-distortion filter 2 operates
Post2Gain -24.0–+24.0 [dB] For the LSV/HSV types, the amount of boost/cut
Post3 Type THRU, LPF, HPF, BPF, PKG
The filter types available for filter 3 after distortion processing.
THRU: No filter is applied
LPF: A filter that passes the sound below the specified frequency
HPF: A filter that passes the sound above the specified frequency
BPF: A filter that passes only the specified frequency
PKG: A filter that boosts/cuts the specified frequency
Post3Frq 20–16000 [Hz] Frequency at which post-distortion filter 3 operates
Post3Gain -24.0–+24.0 [dB] For the PKG type, the amount of boost/cut
Post3 Q 0.5–16.0 Width of the frequency range affected by the filter
Sense -60.0–0.0 [dB]
Adjust this value so that the sound is not made louder when distortion is
applied.
PostGain -48.0–+12.0 [dB] Gain following distortion processing
Balance D100:0W–D0:100W Volume balance between the dry sound (D) and effect sound (W)
Level 0–127 Output Level