Nikon D5500 - Manual (Page 307)

283 B The Setup Menu: Camera Setup
❚❚ Location Data
This item is used to adjust settings for optional GP-1 or GP-1A
GPS units (
0 333). The unit can be connected to the camera’s
accessory terminal ( 0 333) using the cable supplied with the
device, allowing information on the camera’s current position to
be recorded when photographs are taken (turn the camera off
before connecting the unit; for more information, see the
manual provided with the device).
The Location data menu contains the options listed below.
• Standby timer: Choose whether or not the standby timer is
enabled when the unit is attached.
• Position: This item is only available if a GP-1 or GP-1A is
connected, when it displays the current latitude, longitude,
altitude, and Coordinated Universal Time (UTC) as reported by
the unit.
• Set clock from satellite: Choose Yes to set the camera clock based
on the time provided by the satellite navigation system.
Option Description
Enable
Standby timer enabled. The timer expires automatically if
no operations are performed for the time selected for
Custom Setting c2 (Auto off timers) > Standby timer
(
0 253; to allow the camera time to acquire location data,
the delay is extended by up to one minute after standby
timer is activated or the camera is turned on). This
reduces the drain on the battery. Note that the unit will
remain active to acquire location data for a set period after
the timer expires.
Disable
Standby timer disabled, ensuring uninterrupted recording
of location data.
A Coordinated Universal Time (UTC)
UTC data is provided by the location data satellite system and is
independent of the camera clock.