Sony Alpha 9 - Manual (Page 233)

C:\4692676112\4692676112ILCE9UC2\01GB-ILCE9UC2\110TBS.indd
2017/03/15 14:08
ILCE-9
4-692-676-11 (2)
GB
233
If you have pr
oblems
Others
The message [Set Area/Date/Time.] is displayed when you turn on the
product.
• The date and time settings were lost because the battery was left in
the depleted state or removed from the product. Charge the battery
and reset the date and time (page 46). If the clock resets every
time the battery pack is charged, the internal rechargeable backup
battery may be worn out. Consult your service facility.
The number of recordable images does not decrease, or decreases two
images at a time.
• This is because the compression rate and the image size after
compression change depending on the image when you shoot a
JPEG image.
Settings are reset even though the resetting operation has not been
performed.
• The camera settings may be reset if the battery pack is ejected while
the ON/OFF (Power) switch is set to “ON.” When ejecting the battery
pack, first set the ON/OFF (Power) switch to “OFF” and make sure
that the access lamp is not illuminated before ejecting (page 25,
41).
The product does not work properly.
• Turn off the product. Remove the battery pack and insert it again.
If the product is hot, remove the battery pack, and allow it to cool
down before trying this corrective procedure.
• If an AC Adaptor is used, disconnect the power cord. Connect the
power cord and turn on the product again. If the product repeats the
same error often or still does not work after trying these solutions,
consult your Sony dealer or local authorized Sony service facility.
“--E-” appears on the screen.
• Remove the memory card, and insert it again (page 43). If the
problem persists even after performing this procedure, format the
memory card (page 178).