ProSoft Technology MVI56-DFCMR - Manual (Page 30)

MVI56-DFCMR ♦ ControlLogix Platform Installing and Configuring the Module
DF1 Interface Module with Reduced Data Block
Page 30 of 113 ProSoft Technology, Inc.
October 20, 2008
Register Content Description
5034 File Offset This parameter sets the database register location of
the first element in the first file simulated in the
module. All offsets in the first file and subsequent
files will be computed using the address specified.
This value is fixed at 0. Therefore, the module
assumes N7:0 starts at the database offset of 0 and
each file is 200 words in size.
5035 Map Count Number of file map overrides.
5036 to 5039 Spare
2.2.3 Port 2 Setup
Register Content Description
5040 Enable This parameter is used to define if this port will be
utilized. If the parameter is set to 0, the port is
disabled. A value of 1 will enable the port.
5041 Type This parameter defines if the port will emulate a
master or slave device. Enter 0 to emulate a master
device and 1 to emulate a slave device.
5042 Local Station ID This parameter specifies the local station ID for all
DF1 messages sent from this master port. A value of
255 is not permitted as this is the broadcast address.
Enter a value in the range of 0 to 254.
5043 Protocol 0=full duplex, 1=half-duplex
5044 Termination Type This parameter specifies the error checking for all
DF1 messages. 0=BCC, 1=CRC
5045 Baud Rate This is the baud rate to be used on the port. Enter
the baud rate as a value.
Baud Rate Parameter Value
110 110
150 150
300 300
600 600
1200 12 or 1200
2400 24 or 2400
4800 48 or 4800
9600 96 or 9600
14,400 14, 114 or 14400
19,200 19, 192 or 19200
28,800 28, 288 or 28800
38,400 38, 384 or 38400
57,600 57 or 576
115,200 115 or 1152
5046 Parity This is the Parity code to be used for the port. The
coded values are as follows: 0=None, 1=Odd,
2=Even.